Whirlpool FGP320A User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner
flames are
uneven
Burner ports are clogged.
Clean with a straight pin (see pages
19 and 23). If this fails, call an
authorized Roper service technician
for service.
Burner
flames lift off
ports, are
yellow, or
are noisy
when turned
off
Air/gas mixture is incorrect.
Contact an authorized Roper service
technician to check air/gas mixture.
Burner makes
popping noise
when on
Burner is wet from washing.
Let dry.
Controi
knob(s) will
not turn
You are not pushing in before
turning.
Push control knob(s) in before
turning to a setting.
Cooking
resuits are
The range is not level.
Level range. (See Installation
Instructions.)
not what you
expected
The oven temperature seems
too low or too high.
Adjust the oven temperature control.
(See “Adjusting the oven temperature
control” on page 13.)
The oven was not preheated as
the recipe calls for.
Preheat oven if called for in recipe.
The recipe has never been
tested or is not from a reliable
source.
Use only tested recipes from a
reliable source.
The pans are not the type or
size recommended in the
recipe.
Refer to a reliab e cookbook for
recommended pan type and size.
There is not proper air circula
tion around pan when baking.
Allow 1V
2
to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
Adjust flame size to fit cooking
utensil.
When broiling, you have not
completely closed the broiler
drawer.
Completely close broiler drawer.
26