Citizen Systems iDP-3550 - Manual (Page 107)

ESC "*" m n1 n2 [d] n1 + 256
×
n2
(Graphic Type)
[Function] Specifying the bit image mode
[Code] <1B>H <2A>H m n1 n2 [d] n1 + 256
×
2
[Range] m = 0, 1
0
≤
n1
≤
255
0
≤
n2
≤
3
0
≤
d
≤
255
[Outline] This command specifies the bit image for the mode m as to the number of dots specified with
n1 and n2. Divide the number of dots printed by 256 and assume its quotient to be n2 and
remainder to be n1. Therefore, the number of horizontal dots will be n1 + 256
×
n2.
If the bit image data is entered beyond the dot positions printable in one line, the surplus data
will be discarded. The following table shows the bit image modes for m.
Horizontal Direction
Total Dots m
Vertical
Dots Dot Density
Adjacent Dot
Setting DP654 DP657
0 8 Single density Allowed 180 200
1 8 Double density Disallowed 360 400
[Caution] If the value of m is beyond the conditions, the data subsequent to n1 will be processed as
normal data. Normal data processing will be restored after completing bit image print.