Canon DR-3080C - Manual (Page 19)

Installing the Scanner 15
Installing the Scanner
Requirements
In order to install this scanner, you will need the following:
● PC
● SCSI interface cable (→ page 16)
● SCSI interface board
Note
● Some application software may require a device driver that is different
from the one that is provided on the setup disc.
● Make sure that the device driver and application software that you will be
using are compatible with your PC, the system configuration, and the type
of SCSI interface board that you are using.
Installation Procedure
Install the unit according to the following procedure.
1. Connect the SCSI cable to the PC or another SCSI device.
↓
2. Set the SCSI ID and the terminator.
↓
3. Turn the scanner on first, and then start up the PC.
↓
4. Install the necessary software (device driver, application software, etc.) in
your PC.
↓
5. Restart your PC. The scanner is now ready for use.