Carl Goldberg GBGA1083 - Manual (Page 13)

13
Wild Stick .40
3. Center the engine on the firewall
and mark the location of the four
mounting bolts.
4. install the four blind nuts in the
firewall. The best way to install the
nuts is to use a piece of wire to pull
the nuts into place .
5. pull the nuts up with the wire then
install the bolt and washer through
the hole and tighten to finish pulling
the blind nut into the hole.
6.After all four nut are pulled tight,
install the engine using the four 4mm
bolts and washers. Use lock tite on
the bolts.
Radio Installation
1. For the Ailerons you will need
four servos and two 12” servo exten-
sions.