Carl Goldberg GBGA1083 - Manual (Page 10)

10
Wild Stick .40
11. Epoxy the fin in place making sure
it is square to the stab and centered
on the fuselage in the rear.
landing Gear
Collect the following parts:
1. Tail wheel bracket
2. Tail wheel
3. Wheel collar
4. Three 2mm screws
5. Three 2mm washers
1. place the tail wheel bracket on
the bottom of the fuselage with the
tiller are flush against the rear of
the fuselage and centered.
2. Drill a 1/16” hole at the three
holes in the tail wheel bracket.
3. Use the three 2mm screws and
washers to mount the tail wheel
bracket.
4. Install the tail wheel using wheel
collar.
locate the following parts:
1. landing gear
2. Two wheels
3. Two axels
4. two axel nuts
5. Four wheel collars
6. Six flat washers
7. Four mm screws