Carl Goldberg GBGA1024 - Manual (Page 3)

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
*
1 5 CHANNEL RADIO WITH 6 MICRO SER-
VOS. (WE USED 6 CHANNEL FUTABA
RADIO WITH S3108 SERVOS AND GREAT
PLANES ELECTRICFLY RECEIVER W/O
SPEED CONTROL)
*
2 6” SERVO “Y” HARNESS
*
2 6” SERVO EXTENSIONS
*
2 12” SERVO EXTENSIONS
*
1 ELECTRONIC SPEED CONTROL (WE
USED A CASTLE CREATIONS PHOENIX
25 BRUSHLESS SPEED CONTROL)
*
1 3 CELL LI-PO BATTERY (GREAT PLANES
ELECTRICFLY 1500)
*
1 ULTRAFLY BRUSHLESS MOTOR A/30/29
WITH 3.89 GEAR RATIO
*
1 GREAT PLANES ELECTRIFLY PROP
ADAPTER 3MM APC LONG
*
1 APC PROPELLER 9 X4.7 SLO FLYER
*
1 CA ACCELERATOR
*
1 1 OZ. BOTTLE CA MEDIUM GLUE
*
1 1/2 OZ. BOTTLE CA THIN GLUE
*
1 5 MINUET EPOXY
*
1 1/4” FOAM RUBBER
*
1 #2 X 1/4” SHEET METAL SCREW FOR
MOTOR(MIGHT BE REQUIRED FOR SOME
MOTOR INSTALLATIONS)
TOOLS AND SUPPLIES FOR ASSEMBLY .
*
MODELING OR UTILITY KNIFE
*
WORK SURFACE (24" X48")
*
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
*
MASKING TAPE
*
NEEDLE NOSE PLIERS
*
24” RULER
*
FLEXIBLE STRAIGHT-EDGE
*
30-60-90° x 6" TRIANGLE
*
SOFT PENCIL
*
A FEW STRAIGHT OR "T" PINS
*
WIRE CUTTER (DYKES)
*
OPTIONAL HEAT GUN/COVERING IRON
*
ACID BRUSH
* 5 FT. LENGTH OF STRING
Caution:
Before starting, care-
fully go over all high
stress areas (Wing
bolt mounting blocks,
Firewall,etc.) with an
epoxy or wood glue to
confirm all areas are
well glued.