Carl Goldberg GBGA1080 - Manual (Page 9)

9
Radio Installation
1. Collect the following parts:
(1) Fuselage
(2) Micro Servos with Hardware (Not Included)
(1) Micro Receiver (Not Included)
(1) 6” Servo Extension wire (Not Included)
(2) Single keeper
OPTIONAL:
(2) Mini- Pushrod Connectors
2. Screw the rudder servo into place using the
hardware that came with the servo.
Connect the pushrod wire to the servo arm
using optional mini-pushrod connector, or
using a felt marker, mark were the wire cross-
es the servo arm hole.
Single Keeper Servo Arm
3. Install the elevator servo the same way you
did the rudder servo.
Connect your servos to the receiver and place
the receiver in the hole in front of the servos.
Place your battery in front of the receiver. Use
velcro or foam to help hold the battery in
place.
Receiver
Battery
Bend the pushrod wire 90 degrees at the
mark, and slide the pushrod wire through the
servo arm hole from the bottom.
Hold the pushrod wire on to the servo arm by
using a single keeper.
Balancing
Your model should balance at 2-1/4” to 2-1/2” back from the leading edge of the
wing.
Start with the controls movements at the following:
Ailerons 1/4” up and down
Elevator 1/4” up and down
Rudder 1/4” up and down
You might want to change these throws after you are
comfortable flying the Eagle 400.
Installing wheels
1. Collect the following parts:
(1) Fuselage
(3) Wheels
(3) Plastic wheel retainers
Slide each of the wheels onto the landing gear
wire.
Using pliers push the wheel retainers onto the
wire.