Carl Goldberg GBGA1080 - Manual (Page 4)

4
Wing
Installing Ailerons
1. Collect the following parts:
(1) Wing
(2) Ailerons ( Left & Right)
(6) Mini CA hinges
1. Locate the pre-cut aileron hinge slots in both
sides of the wing. Using a hobby knife (#11
blade), slide the blade into each slot to make
sure it is cleanly cut.
Repeat this process with the ailerons, making
sure all hinge slots are clean.
2. Place a drop of white glue on the aileron
torque wire coming out of the wing were the
aileron attaches. Then insert the mini CA
hinges half way into the wing and the ailerons.
(Use a pin inserted into the middle of the
hinge to help keep the hinge in the middle.)
Make sure that the aileron is tight against the
wing and even with the wing tip.
Using thin CA glue, place one drop on all three
hinges top and bottom.
Repeat these steps for the next aileron.
3. Locate the pre-assembled aileron servo tray.
Hold the tray over the hole in the bottom of the
wing.
Mark where the sticks on the bottom of the tray
rest on the wing.
Remove the covering from the wing were the
sticks will rest. (Do Not Cut into the Wood!)
Glue the tray into place.
Remove