Carl Goldberg GBGA1080 - Manual (Page 5)

5
2. Follow the instructions that came with your
radio, and mount the aileron servo.
Aileron Servo
1. Collect the following parts:
(1) Wing
(1) Servo with hardware
(2) Aileron pushrod
(2) Mini snap Links
(2) Keepers
(2) Adjustable horn brackets
Thread the adjustable brackets on to each of
the threaded rods that are sticking out of the
wing.
Adj Horn Brackets
Aileron Torque Rods
Thread a snap link onto each of the threaded
rods.
3. Open the snap link and mount it to the
adjustable horn bracket.
Mark where the pushrod meets the outer hole
on your servo.
4. Bend the push rod wire at the mark and insert
the pushrod wire through the bottom of the
servo arm. (You may have to drill the servo
arm for the wire to fit through).
place a snap-r-keeper onto the wire and clip it
to the pushrod.
Repeat for the next aileron.
Fuselage
Stabilizer
1. Collect the following parts:
(1) Fuselage
(1) Stabilizer & Elevator
(1) wing with mounting screws and washers
Front hole
2. Locate the holes in the center of the wing for
the wing bolts. Remove the covering over
these holes.
Mount the wing to the fuselage using the long
bolt and washer for the front of the wing, and
the short bolt and washer for the rear of the
wing
Make sure that the wing is perpendicular to
the fuselage by measuring from both wing tips
to the rear of the fuselage, the measurement
should be approximately the same.