CAMCORP Blower Package with Sutorbilt Blower - Manual (Page 20)

SB-7-621 Page 7
INDEX
Aeon PD Food Grade Lubricant ..................................... 18
Aeon PD Synthetic Lubricant.......................................... 18
Air Filters And Filter Silencers ........................................ 16
Assembly Instructions, Section 7 .................................... 28
Blower Startup Checklist................................................. 21
Disassembly Instructions, Section 6 ............................... 25
Drive End Lubrication ..................................................... 17
Drive Installation ............................................................. 13
Equipment Check, Section 1
Equipment Check ........................................................... 10
Foundations.................................................................... 12
Gear End Lubrication...................................................... 17
Installation, Section 2...................................................... 12
Installing The Timing Gears............................................ 31
Introduction....................................................................... 9
Limitations ...................................................................... 20
Location .......................................................................... 12
Lubrication, Section 3 ..................................................... 17
Mechanical Seals Only ............................................. 28, 29
Mounting Configurations................................................. 12
Operation, Section 4....................................................... 20
Parts List, Section 8........................................................ 35
Piping ............................................................................. 14
Recommended Lubricant ............................................... 18
Removing Protective Materials ....................................... 10
Repositioning The Mounting Feet................................... 12
Safety Precautions ........................................................... 5
Safety Precautions ......................................................... 22
Section 7
Assembly Instructions..................................................... 28
Setting Impeller End Clearance With Mechanical Seals. 33
Setting Impeller End Clearances .................................... 32
Special Tools Required Section 5................................... 23
Storage ........................................................................... 10
Trouble Shooting ............................................................ 22
Warranty ......................................................................... 44
LIST OF ILLUSTRATIONS
FIGURE 2-1 – BLOWER MOUNTING CONFIGURATION ............................................................................. 13
FIGURE 2-2 – BELT DRIVE OVERHUNG LOAD CALCULATIONS .............................................................. 15
FIGURE 3-1 - LUBRICATION......................................................................................................................... 17
FIGURE 3-2 – APPROXIMATE OIL CAPACITIES ......................................................................................... 18
FIGURE 3-3 – AEON PD SYNTHETIC LUBRICANT ..................................................................................... 18
FIGURE 3-4 – LUBRICATION RECOMMENDATION .................................................................................... 19
FIGURE 4-1 – MAXIMUM OPERATING LIMITATIONS ................................................................................. 20
FIGURE 5-1 – PULLER PLATE...................................................................................................................... 23
FIGURE 5-2 – GEAR DRIVER
– 208GAA074 ............................................................................................. 23
FIGURE 5-3 – MECHANICAL SEAL INSTALLATION TOOL ......................................................................... 24
FIGURE 5-4 – BEARING PRESS TOOL – MECHANICAL SEAL UNITS....................................................... 24
FIGURE 6-1 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 25
FIGURE 6-2 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 25
FIGURE 6-3 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 26
FIGURE 6-4 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 26
FIGURE 6-5 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 26
FIGURE 6-6 – DISASSEMBLY ILLUSTRATIONS.......................................................................................... 27
FIGURE 7-1 – ASSEMBLY ILLUSTRATIONS................................................................................................ 28
FIGURE 7-2 – ASSEMBLY ILLUSTRATIONS................................................................................................ 29
FIGURE 7-3 – ASSEMBLY ILLUSTRATIONS................................................................................................ 29
FIGURE 7-4 – ASSEMBLY ILLUSTRATIONS................................................................................................ 30
FIGURE 7-5 – ASSEMBLY ILLUSTRATIONS................................................................................................ 31
FIGURE 7-6 – ASSEMBLY ILLUSTRATIONS................................................................................................ 33
FIGURE 7-7 – ASSEMBLY ILLUSTRATIONS................................................................................................ 33
FIGURE 7-8 – TORQUE (FT-LBS) .................................................................................................................
34