Cadillac 2007 Escalade - Manual (Page 175)

To put the cover in the vehicle, do the following:
1. Make sure the cover slot in the holder
faces rearward with the round surface
facing down.
2. Then, hold the cover at an angle and
place the cover endcap into the slot in
the passenger’s side trim panel.
3. Move the other end of the cover forward
and hold it next to the driver’s side trim
panel slot.
4. Press the endcaps in, this will allow the
cover to fit into the trim slot.
5. Lightly pull on the cover holder to make
sure it is secure.
On the extended wheelbase models there
are two cover positions. The slots furthest
forward allow the cover to be used if the
third seat is removed or folded down.
The cover can be installed and removed
from either side.
Cargo Tie Downs
Your vehicle may be
equipped with cargo tie
downs in the rear
cargo area that allow
you to strap cargo
in and keep it from
moving inside the
vehicle.
When not using the tie downs, flip them down out
of the way.
175