C&D Technologies RS-1942 L Series NEBS Compliant Racks - Manual (Page 8)

RS 1942
C&D technologies
General: These ins
installing C&D NEB
describes how to lo
racks for C&D batte
attention to these in
trouble-free perform
Rack Location: Loc
the batteries are no
such as sunlight, he
Variations of more t
cause the battery to
ranges. Top rows of
tend to operate at s
on lower tiers. Alwa
for ventilation and m
Anchoring: To prov
racks must be secu
are to be installed p
accordance with ap
walls without consu
provided in the base
secured to floor usin
responsibility of the
accordance with allo
codes and regulatio
Grounding: Rack g
the base of each fra
are located at the ce
and may be used to
two holes have 1.0”
been masked and a
electrical contact. F
accomplished via th
each frame with an
DETAIL #4 Battery Restraint Assembly Details.
Typical Bolted Connections Continued: These typical details are to be used unless detailed specifically on drawing.
CONNECTION DETAILS FOR RACK ASSEMBLY.
Bracket
Tie Rod and Poly Tubing
Corner Bracket
3/8-16 x 1.00 Bolt
and 3/8 Lock Washer
Serrated Strut Nut
End Restraint Rail
and Cover.
Serrated Strut Nut
5/16-18 Nut and
5/16 Lock Washer
3/8-16 x 1.00 Bolt
and 3/8 lock washer
DETAIL #5 End Restraint Assembly Detail.
1400 Union Meeting Road
P.O. Box 3053 • Blue Bell, PA 19422-0858
(215) 619-2700 • Fax (215) 619-7899 • (800) 543-8630
[email protected]
www.cdtechno.com
Any data, descriptions or specifications presented herein are subject to revision by C&D Technologies, Inc. without
notice. While such information is believed to be accurate as indicated herein, C&D Technologies, Inc. makes no
warranty and hereby disclaims all warranties, express or implied, with regard to the accuracy or completeness of such
information. Further, because the product(s) featured herein may be used under conditions beyond its control, C&D
Technologies, Inc. hereby disclaims all warranties, either express or implied, concerning the fitness or suitability of
such product(s) for any particular use or in any specific application or arising from any course of dealing or usage of
trade. The user is solely responsible for determining the suitability of the product(s) featured herein for user's
intended purpose and in user's specific application.
Copyright 2003 C&D TECHNOLOGIES, INC. Printed in U.S.A. RS-1942 5M/1202/TD/1
“L” SERIE
STANDBY
ASSEMBLY
RSO1942 2/18/03 4:05 PM Page 1