Burris C4 Plus - Manual (Page 7)

Care & Maintenance
The C4 Plus riflescope is fully waterproof and fogproof.
In the event that the lenses are subjected to dust, dirt
or mud, follow these steps to clean and protect the lens
surface. Failure to remove grit before final cleaning is
sure to damage lens coatings.
Coarse dirt/debris must be removed from the lens
surface. The most convenient way to clean a lens surface
is to use a Lens Pen. Position the scope so particles will
fall away from the lens, and then use the Lens Pen
or soft brush to gently whisk away the debris, while
blowing on the lens to dislodge the particles. For heavy
dirt, like dried mud, use a spray of clean water or lens
cleaning fluid to remove the dirt.
Your Burris riflescope will provide reliable performance
given reasonable care and treatment. All moving
assemblies are permanently lubricated. Only occasional
cleaning of the outside of the scope and the exterior
lenses is required. Never disassemble your scope.
If you have any other problems with your riflescope,
please return it to the Burris factory for repair.
6
Mounting the Scope
C4 Plus riflescopes are available with either 1” or
30mm body tubes; please be sure you choose the
correct ring sizes for your model as indicated by the
end label sticker on your riflescope box . We recom-
mend using high-quality rings and bases, like Burris
Zee Rings or Signature Rings. Quality components
ensure that your scope will remain safely and securely
mounted, and will provide the maximum accuracy.
Use care when mounting your scope as damage can
occur