Burris C4 Plus - Manual (Page 6)

Installing the Wind Map
Each Wind Map is shaped such that it can be easily
installed and used in multiple positions such as the
Objective Bell Taper, the Eyepiece, or the Riflestock.
Our recommendation is to install the WindMap on the
Objective Bell taper approximately 10° – 20° left or
right of the top center depending on whether you
shoot right- or left-handed. This position allows you to
see the Wind Map with your “off-eye” while viewing
through the scope. It also provides for a somewhat
protected position against scratching.
Locate exactly where you want to place the Wind Map
and clean the surface of any dust and oils with soapy
water or rubbing alcohol. Peel off the adhesive covering
on the back of the Wind Map and carefully install at
your desired location.
Eyepiece Focusing
The eyepiece can be focused so that the reticle appears
sharp and black to your eyes. Follow this procedure to
adjust the focus:
1. Point the scope at the sky or a plain wall and take
a quick glance through the scope. If the reticle
appears sharp and black, no further adjustment is
necessary.
2. If the reticle does not appear sharp and black, take
quick glances through the scope while rotating the
focus ring until the reticle pattern is sharp and clear.
NOTE: Do not look through the eyepiece as you turn the
focus ring. Your eyes will adjust to the out-of-focus
condition.
5