Burris C4 Plus - Manual (Page 4)

Installing Your Custom Clicker Elevation Knob
1. It is best to sight-in your riflescope prior to installing
your Custom Clicker.
2. Being careful not to
rotate the elevation
knob, loosen the three
set screws that hold the
elevation knob in place.
Lift the knob up and off
of the scope.
3. Place the Custom
Clicker onto your scope,
aligning your sight-in
yardage number to the
reference mark on the
scope.
4. Apply a small amount
of downward pressure
onto the Custom Clicker
and then evenly tighten
the three set screws.
Turn your Custom
Clicker about a half-turn
counter-clockwise and
then clockwise back to your sight-in distance to get a
feel for the amount of resistance to turn the clicker. If
you desire more or less resistance, loosen the three set
screws and apply more or less downward pressure
onto the Custom Clicker; retighten the set screws.
Retest and reset the resistance until satisfied.
3