Bullet Tools SST226 - Manual (Page 7)

7
AccESSORIES
All Angle Fence
Item #701AF
Set any angle from 0
º to 90 º
Shear Stand
Item #709
Allows you to cut with the shear
off the ground�
Honing the blade
MAInTEnAncE
Push the handle down until blade is 1/4” (6mm) open.
Lay the hone stone against the flat face of the blade
(side toward the table). Slide from end to end 2 or 3 times.
This removes the small burr formed when cutting hard
products.
Hone every 100 cuts
lubricating
After every 100 cuts, it is recommended that you lubricate
the wear points of the pins and the bearings as shown.
Use a light oil (i.e. 10W motor oil). This will prevent the
machine from wearing out prematurely. Apply grease
(wheel bearing grease) frequently to the bearings where
indicated�
Oil
Grease
Your EZ Shear cuts a wide variety of products.
Please refer to this cut guide for
recommended products and thicknesses.
Please note: Approved materials may vary in density
and hardness. If extreme pressure is required to cut
a product, it may result in damage to your machine.
Please contact Bullet Tools before proceeding. Warranty
is void if an unapproved product damages the machine.
SST CUT GUIDE
Maximum Thickness = 25mm or 1”
Material
Do NOT Use on
High Pressure Laminate
or Solid Wood!
Replacement Blade for SST220 is part #220B
Replacement Blade for SST226 is part #226B
Special Soft Product Blade for SST220 is part #220SP
Special Soft Product Blade for SST226 is part #226SP
Siding, Fiber Cement Board
Siding, Pressboard Lap
Siding, Vinyl
Siding, Wood
Trim, OSB
Trim, Fiber Cement
Trim, Vinyl
Shingles, Tar or Wood
Engineered Wood
Commercial Vinyl
Luxury Vinyl Tile
Parquet
Permastone ™
PVC Tile
Rubber Cove Base
Rubber Tile
Soft Plastic