Bullet Tools SST226 - Manual (Page 5)

5
2
While gently pushing handle
down, pull Safety Lock Pin out,
then lift handle.
1
3
5. PlAcE THE FEncE
For 220:
Your EZ Shear is equipped with an aluminum fence
which may be set to common roof pitches. (4/12, 6/12,
8/12, and 12/12) Simply align with desired position
and press pins into place.
Note: The fence is friction fit (requires effort to insert or
remove).
For 226:
Slide fixed clamp into the front quick alignment notch.
For 90° cuts, slide loose clamp into rear alignment
notch and tighten star knob.
For angle cuts:
1) Align edge of fence with the desired angle guide
mark in center of table.
2) Slide loose clamp to edge of table and tighten knob.
220
226
Pull Safety Lock pin
mAKING CUTS
Place product on
table� Bring handle
down until blade
touches material�
Push the handle
down until
the material is
completely cut.
5
Caution! Wear hand and eye protection while operating the EZ Shear™