Product information, Assembly, 1 unpacking – Boekel Scientific 230301-2 Bambino II User Manual
Page 4: 2 installation, Operation, 1 controls and indicator lamps (see figures 1 & 2), 2 setting the temperature
3
2. Product Information
The Boekel Hybridization Oven Model 230301 & 230301-2 hybridization oven will
hold up to four 50ml plastic centrifuge tubes. The Oven can also be used with other
size tubes using the optional carousel.
The Boekel Hybridization Oven utilizes an adjustable speed Carousel and forced
air circulation coupled with proportional (PID) temperature control that combine to
provide unsurpassed temperature performance and the most consistent conditions
from procedure to procedure. Please note that the convection fan operates
continuously whenever the unit is turned on.
3. Assembly
3.1 Unpacking
Remove packing materials carefully, and retain for future shipment or storage of
the unit. Inspect for damage. Report all shipping damage to the carrier
immediately. Shipping damage is covered by the carrier and repair/replacement
for shipping damages must be coordinated through the carrier. Complete and
return the Warranty Registration Card. Packs should contain:
Hybridization Oven
Power line cord
Operating instructions
3.2
Installation
Place the Oven on a flat and stable surface, preferably away from drafts. Fit the
power line cord into the IEC power socket on the rear of the unit.
4. Operation
4.1
Controls and Indicator lamps (see figures 1 & 2).
The Power Switch controls power to the unit.
The temperature display shows the chamber temperature in degrees Celsius.
The Speed Control knob regulates the speed of the Carousel.
The heater lamp is on continuously while the Oven is heating up. As the required
temperature is approached, it starts to flash. When the unit is controlling at the
set temperature, the heater lamp flashes intermittently.
4.2
Setting the temperature
The temperature controller has three buttons. When the button on the left ‘*’ is
depressed, it will display the set temperature. When the left button ‘*’ is
depressed simultaneously with the middle button ‘
▼’, the set temperature value
is lowered. When the left button ‘*’ is depressed simultaneously with the right