Boekel Scientific 234100-2 UV Crosslinker AH - Manual (Page 8)

N2400340 Rev. 2 Page 8
in Energy Mode, the display shows the accumulated energy and the
calculated target time to reach that energy level.
If Time Mode is selected and the “Start/Stop” key is pressed, the
controller sounds a brief beep and the display shows the following for 1
second:
The following screen is then displayed.
TIME blinks briefly every two seconds to remind the user that they are in
Time Mode. A small UV icon appears in the upper right of the display
to show the user that the UV is energized. While in Time Mode, the
display shows the countdown time and the accumulated energy.
Pressing the “Start/Stop” key during a cycle shows the following for 1
second:
The user is returned to the main screen in paused mode where they
can adjust the target energy or time. “CYCLE PAUSED” blinks every 2
seconds to remind the user that the cycle is paused. Once the user is
finished adjusting they can press the “Start/Stop” key to continue the
cycle.
Pressing the “Reset” key sets the time back to the last entered setting
and the display shows the following for 1 second. Important: This also
resets the accumulated energy.
When the set time reaches zero in the Time Mode or the target energy
is reached in Energy Mode, the display shows “CYCLE COMPLETE” and
the alarm beep is energized 3 times. The user is returned to the main
screen and CYCLE COMPLETE is flashed every 3 seconds until a key is
pressed.
STARTING CYCLE
TIME MODE
TIME: 02:00
UV
ENERGY: 120000 uJ
CYCLE
PAUSED
CYCLE
RESET