Boekel Scientific 240000-2 Slide Moat - Manual (Page 8)

7
8.0 Maintenance and Service
All Boekel laboratory products are designed to comply with
IEC1010-1. No routine maintenance is required.
8.1 Cleaning
Disengage power cord prior to cleaning. If a spill occurs, use
appropriate clean-up procedures as required for radiation or
biohazard control. The outer casing can be cleaned with a cloth
dampened with water. Do not immerse the unit in water.
8.2 Replacement of Fuses
There are two supply fuses located in the fuse drawer. To change
the fuses:
• Turn power switch to the off (O) position
• Disconnect the unit from the power supply
• Remove the line cord from the power entry module on the back
of the unit
• Pull back on the fuse drawer catch
• Pull out the fuse drawer
• Check and replace with the correct fuses if necessary. The
fuses should be 5mm x 20mm quick acting, rated 250V.
Model 240000 (115 V AC): 2AF
Model 240000-2 (230 V AC): 1AF
• Push the fuse drawer back in. Reconnect unit to power supply.
9.0 Warranty
When used in laboratory conditions and according to these
operating instructions, Boekel warrants this product to be free of
defective material and workmanship for a period of two years from
the date of manufacture. The liability of Boekel for any defective
equipment during the warranty period shall be limited to the repair
of such equipment or replacement thereof without charge for parts
or labor.
10.0 Service
It is required to obtain a Returned Material Authorization (RMA)
number before any Boekel products are returned for any reason. A
Decontamination Certificate must be completed, signed by the
user, and returned to Boekel Scientific prior to receiving the RMA
number. Please be sure to mark the outside of the returned goods
package with this RMA number to ensure prompt handling