Product information, Assembly, 1 unpacking – Boekel Scientific 14792-2 Round Tissue Bath User Manual
Page 4: 2 installation, Operation, 1 controls and indicator lamp, 2 setting the temperature

3
2. Product Information
The Boekel Round Tissue Bath is designed as an economical and efficient tissue floatation
bath for use in mounting tissue specimens to glass slides.
The Round Tissue Bath has an 8.5” (21.6cm) diameter by 2” (5cm) deep-water chamber
with a 1.25” (3.2cm) wide rim for slide warming and drying. The Tissue Bath has a water
temperature range of ambient + 10
°C to 65°C under normal operating conditions.
3. Assembly
3.1 Unpacking
Remove packing materials carefully, and retain for future shipment or storage of the unit.
Inspect for damage. Report all shipping damage to the carrier immediately. Shipping
damage is covered by the carrier and repair/replacement for shipping damages must be
coordinated through the carrier. Complete and return the Warranty Registration Card.
Packs should contain:
• Round Tissue Bath
• Operating Instructions
• Bath Cover
• Thermometer Holder
3.2
Installation
Place the Round Tissue Bath on a flat and stable surface, preferably away from drafts.
Plug power cord into a power supply that matches the voltage listed on the serial number
label on the rear of the unit.
4. Operation
4.1
Controls and Indicator Lamp
The Power Switch controls power to the unit.
The heater lamp is on continuously while the bath is heating up. As the required
temperature is approached, it starts to flash. When the bath is controlling at the set
temperature, the heater lamp flashes intermittently.
4.2
Setting the Temperature
To increase bath temperature, rotate the thermostat knob in the clockwise direction. To
decrease bath temperature, rotate the thermostat knob in the counterclockwise direction.
Allow about 60 minutes for the bath to equilibrate from a cold start. A thermometer may
be used to check exact bath temperature. Allow 5 to 10 minutes for the bath to re-
equilibrate when adjusting the bath temperature from a previous set point. If the bath is
to be operated at the same temperature in the future, the thermostat setting should not be
disturbed. Just turn the bath off using the On/Off switch.