beautypg.com

Power windows – BMW 2013 5 Series User Manual

Page 43

background image

The doors, hood or trunk lid is not closed
properly, but the rest of the vehicle is se‐
cured.
After 10 seconds, the indicator lamp flashes
continuously. Interior motion sensor and tilt
alarm sensor are not active.

The indicator lamp goes out after unlocking:
The vehicle has not been tampered with.

The indicator lamp flashes after unlocking
until the engine is started, but no longer than
approx. 5 minutes:
An alarm has been triggered.

Tilt alarm sensor

The tilt of the vehicle is monitored.
The alarm system responds in situations such
as attempts to steal a wheel or when the car is
towed.

Interior motion sensor

The windows and glass sunroof must be closed
for the system to function properly.

Avoiding unintentional alarms

The tilt alarm sensor and interior motion sensor
can be switched off together, such as in the fol‐
lowing situations:

In automatic car washes.

In duplex garages.

During transport on car-carrying trains, at
sea or on a trailer.

When animals are to remain in the vehicle.

Switching off the tilt alarm sensor and

interior motion sensor

Press the remote control button again
within 10 seconds as soon as the vehicle

is locked.
The indicator lamp lights up for approx. 2 sec‐
onds and then continues to flash.

The tilt alarm sensor and interior motion sensor
are switched off until the vehicle is locked again.

Power windows

General information

Take the remote control with you
Take the remote control with you when

leaving the vehicle so that children, for example,
cannot operate the power windows and injure
themselves.◀

Opening

Press the switch to the resistance

point.
The window opens while the switch is held.

Press the switch beyond the resist‐

ance point.
The window opens automatically.

Pressing again stops the motion.
Convenient opening, refer to page

34

, via the

remote control.

Closing

Keep the closing path clear
Monitor the closing process and make

sure that the closing path of the window is clear;
otherwise, injuries may result.◀

Pull the switch to the resistance point.

Seite 43

Opening and closing

Controls

43

Online Edition for Part no. 01 40 2 903 008 - 07 12 490