Customer service center – Behlen 54110048 User Manual
Page 5
ASSEMBLY INSTRUCTIONS
THANK YOU FOR PURCHASING THIS PRODUCT
For questions about this product, or for parts inquiries, please contact our Customer Service Center listed below.
Cleaning the Franklin BV Valve and
Replacing the Plunger & Seal
Hardware Pkg.
54300978
F-20201
TECHNICAL INFORMATION 70115
11-4-04
CUSTOMER SERVICE CENTER
PO Box 569
Columbus, NE
68602-0569Ph: 1-800-447-2751
Fax: (402) 563-7447
www.behlencountry.com
STEP 1
Remove the packaging tape from around the top of the valve.
STEP 2
Slide off cover,
pivot upper arm up,
and remove the plunger.
STEP 3
Clean the rubber part of the plunger and opening to the
valve of any mineral deposits or dirt buildup that may be
obstructing the normal operation of the valve.
STEP 4
If the rubber seal is grooved but still pliable (not hard and brittle), you may
flip it over and use the backside of the seal. If both sides of the seal are
hard, replace both the plunger and the seal.
STEP 5
Replace the plunger with the nipple facing you
and the rubber facing the valve.
STEP 6
Replace the cover to complete the cleaning of the valve.
Rubber
Valve
Opening