Behlen 80110060YEL - Manual (Page 9)

Grease Fittings Lubrication
For all grease fittings use a SAE high-temp
multi-purpose lithium grease. Do not let excessive
grease collect on or around parts, particularly
when operating in sandy areas.
Be sure to clean grease fittings before applying
any grease.
Daily lubrication of the driveline U-joints is
necessary. Failure to maintain proper lubrication
will result in premature wear and damage to the
U-joints, gearbox, and/or driveline.
Lubrication Frequency
• Every 8 hours or daily - Gauge Wheel Pivots,
Wheel Hubs, Blade Spindle, U-joints, Driveline
Slip Joint. Lubrication intervals are for mowers
operating under normal conditions. Severe or
unusual conditions may require more frequent
lubrication.
Lubricating the Gauge Wheel is not necessary.
The Wheel Pivot Shaft has a zerk fitting to
grease the wheel pivot. Failure to lubricate the
Driveline Slip Joint every 8 hours or daily, could
result in damage to the U-joints, gearbox, and
driveline.
• To lubricate Driveline Slip Joint, lower mower to
ground, disconnect driveline from tractor PTO
shaft and slide halves apart, but do not
disconnect from each other. Apply a bead of
grease completely around male half where it
meets female half. Slide drive halves over each
other several times to distribute grease.
• Inspect all guards to insure they are in good
working order. If not, replace before using.
• Check all bolts and nuts to insure they are tight
and secure.
TRANSPORT SAFETY
•
Always observe state and local laws governing
highway safety and the travel of farm machinery
on public roads.
• The use of flashing amber lights is acceptable in
most locations. However, some locations
prohibit their use. Local laws should be
checked for all lighting and marking
requirements.
• When driving the tractor and equipment on
roads or highways, use flashing amber warning
lights and a slow moving vehicle (SMV)
identification emblem. Do not exceed 20
mph. Reduce speed on rough roads and
surfaces.
•
Plan your route to avoid heavy traffic.
• Always install transport locks, pins or
brackets before transporting.
• Do not drink and drive.
• Be a safe and courteous driver. Always yield
to oncoming traffic in all circumstances,
including narrow bridges, intersections, etc.
Watch for traffic when crossing or operating
in close proximity to roadways.
• Turn curves and go up and down hills only
at a low speed at a gradual steering angle.
Make certain that at least 20% of the tractor’s
weight is on the front wheels to maintain safe
control. Slow down on rough and /or
uneven surfaces. Always check tractor
manual for proper use on slopes.
•
Use extreme care and maintain minimum
ground speed when operating close to
ditches and/or fences. Be careful when
turning sharp corners.
• Never allow riders on either the tractor or
mower.
ATTACHING TO TRACTOR
Never stand, or allow anyone else to stand,
between the tractor and the Rotary Cut
Mower while backing the tractor up to the
hitch.
Step 1 Attach to the tractor’s 3-Point hitch as
described in the Tractor’s Operator’s
Manual.
Step 2 Apply any multi-purpose grease to the
outside of the male (inner) PTO shaft
section. Assemble PTO shaft and
install on Rotary Cut Mower and
tractor.
Failure to install the retaining clip on the
gearbox input shaft would allow the
driveline to swing freely if the bolt is
sheared causing possible injury or death.
WARNING
WARNING
F-20857 1-12-11