Compaq MV 540 - Manual (Page 7)

5
6. Connect the power cord to the back of the monitor
3aaaa, then connect the power cord to a power
outlet
5.
WARNING: To reduce the risk of electric shock or damage to your equipment, do not disable
the power cord grounding feature. This equipment is designed to be connected to a grounded
(earthed) power outlet that is easily accessible to the operator. The grounding plug is an
important safety feature.
WARNING: For your safety, be sure that the power outlet you plug your power cord into is
easily accessible and located as close to the equipment operator as possible. When you need
to disconnect power to the equipment, unplug the power cord from the power outlet by
grasping the plug firmly. Never pull on the cord.
CAUTION: For the protection of your monitor as well as your computer, connect all power
cords for your computer and its peripheral devices (monitor, printer, scanner, and so on) to
some form of surge protection such as a power strip or UPS (Uninterruptible Power Supply).
Not all power strips provide surge protection; they must be specifically labeled as having this
ability. Look for manufacturers that have a Damage Replacement Policy to replace your
equipment if their surge protection fails.
7. Install your speakers using one of the methods listed in “Speaker Installation.”
8. Power on your monitor by pressing the power button
7. Power on the speakers by pressing the
power button on the side of the right speaker.
If necessary, adjust the front panel controls according to your personal preference.
Your monitor installation is now complete.
Speaker Installation
Headphone/Audio Input Jacks Retractable Speaker Mechanism Speaker Stand
Insert the headphone connector
(headphones not included) into the
headphone jack.
Insert one end of the cable from
your portable audio device (not
included) into the speaker.
1. Rotate the thumbwheel up to extend
the hook mechanism.
2. Align the hooks with the slots on the
monitor, then gently insert the hooks
into the slots and slide down to lock in
place.
Insert the speaker stand into the slot on
the rear of each speaker.