AquaCraft Mini Rio - Manual (Page 6)

6
4. Turn the transmitter “ON” using the
switch on the transmitter’s left side.
The battery level indicator light
(LED) should glow red. If the light
is fl ashing, the batteries are low
and need to be replaced.
5. The completed transmitter.
1. The antenna tube has the receiver
antenna pre-installed in the tube.
Align the antenna tube with the
rubber bushing.
2. Slip the tubing into the rubber bushing. To make this easier you can
place a small amount of cooking oil on your fi nger, wipe any excess
off your fi nger and lightly touch or coat the base of the antenna tube.
Slip the antenna in place, being careful not to push the tube in too far.
INSTALLING THE RX ANTENNA INTO THE HULL OF THE BOAT