CON-TECH CS2000-QD - Manual (Page 7)

- 5 -
Installation
Mounting:
The CS2000 comes with 8 mounting holes allowing for many different mounting options. The
holes are tapped for #8-32 screws and are 0.31" deep. We suggest using #8-32 x 3/8"
stainless steel screws. Some different options are shown below.
* To avoid electro-static discharge and sensor malfunction, the CS2000 should be mounted to
a grounded metal surface. If this is not possible, a grounding wire should be connected from
one of the mounting screws to a suitable ground.
FORK