Antari LCU-1 - Manual (Page 8)

 Occupation of the DIP switches:
￭ Operation
․ Plug power cord into a grounded electrical outlet. If necessary, turn
power switch on rear of unit to “ON” position.
․ To extrude liquid, press the appropriate button on the remote for the
desired length of time.
․ For further information on operating your ANTARI Liquid Control Unit,
refer to the Antari onboard, “Remote Control Operation”.
․ For details regarding DMX, refer to the Antari onboard DMX fog
machine settings section.
If you experience low output, pump noise or no output at all, unplug
immediately. Check Tank fluid level, the external fuse, remote
connection, and power from the wall. If all of the above appears to be
O.K., plug the unit in again. If fluid does not come out after holding the
remote button down for 30 seconds, check the tube attached to the tank
to make sure there is fluid going through the tube. If you are unable to
8