Antari Z-800II - Manual (Page 6)

6
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable
level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the
external fuse, remote control connection and power from the wall. If all of the above appears to be O.K.,
plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check
the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to
determine the cause of the problem, do not simply continue pushing the remote button, as this may
damage the unit. Return the machine to your ANTARI dealer.
Technical Specifications
Model Z-800II Z-1000II Z-1020
Power Supply AC100-120V, AC 220-240V / 50HZ - 60HZ
Power Consumption 800 W 1,000 W 1,000 W
Output Volume 85 m³/min. 284 m³/min. 284 m³/min.
Tank Capacity 0.8 liters 1.7 liters 2.4 liters
Fluid Consumption 60 min./ 0.8 liter 18 min./ liter 11 min./ liter
Weight 3.5 kg 6.6 kg 9.8 kg
Dimensions (LxWxH) 315 x 128 x 165.5 mm 433 x 198 x 151 mm 370 x 295 x 135 mm
Remote Included Z-10 Z-10 Z-10
Optional Remote Z-40, Z-50 Z-40, Z-50 Z-40, Z-50
Warm-up Time 1.7 min. 5.5 min. 11 min.
Remote Control Operation

Z-10: 10 meter wired remote controller with 6,3 mm jack plug of ANTARI Fog Machine models Z-800II, Z-
1000II and Z-1020. The red lamp indicates that the unit is receiving power. When the fog machine has
reached operating temperature the green light on this remote control will light up, indicating that the
operator may begin fog emission by pressing the red button. The green light flashes during fog machine
warm-up and re-heating cycles (approx. 1-2 minutes), and stays ON when the machine becomes
operational. The Z-10 features the
“toggle switch’’ function: press once for continuous “ON”, press again to
release continuous “ON” function

Z-40: 10 meter wired remote controller with 6,3 mm jack plug for ANTARI Fog Machine models Z-800II, Z-
1000II and Z-1020. Its two knobs allow the operator to customize fog machine functions by adjusting
output duration and interval. Press the yellow TIMER-button to activate the timer function. Adjust the
interval between each fog emission (within the range of 10 second to 250 seconds) by means of the
INTERVAL control knob. Adjust the duration of each fog emission (within the range of 10 to 120 seconds)
by means of the DURATION control knob. When pressed, the green FOG button overrides all other
control functions and activates maximum output. Press the red POWER ON/OFF button for continuous
output.

Z-50: Wireless remote controller with 6,3 mm jack plug for ANTARI Fog Machine models Z-800II, Z-1000II
and Z-1020. A remote operation is possible up to a distance of 50 meters. Keep the red button pressed for
fogging.
Z-10, Z-40, Z-50 Remote Controller