Antari Z-800II - Manual (Page 5)

5

Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the
machine. The unit will take a couple of minutes to warm up the heater. During this time the machine
cannot generate fog. When the remote control is attached the red lights (on Z-800II handle) and green
light (on the remote) will flash and stay ON when the warm-up time is complete.

To emit fog press the button on the remote (if it is connected) and on the handle (for Z-800II) for the
desired length of time.

For further information on operating your ANTARI Z-800II, Z-1000II and Z-1020 Fog Machine, see the
section titled
“Remote Control Operation”.
Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the unit.
Z-1000II: Your model includes a mounting bracket designed for overhead installation; it may be
installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it
is important that the fog does not shoot directly at any one
’s face. Whatever installation method
you choose, do not allow the unit to have more than a 25 degree angle of inclination.
Z-1000II Description