AltiGen IP 710 - Manual (Page 28)

20 IP 710 Manual
Registration from the Phone’s Menu
Under normal circumstances, the IP 710 phone registers itself
automatically. However, if registration failed for some reason (for
example, the server was not available), registration can be started again
from the IP 710 phone’s menu:
1. Press the
Menu button.
2. Scroll to REGISTER.
3. Press the
Enter button.
Configuring IP Settings
An IP address is a unique logical address that identifies each host computer
on a TCP/IP network. An IP address is a 32-bit number expressed as four
decimal numbers from 0 to 255, separated by periods.
Use these guidelines when manually configuring the IP settings:
• Ensure the default gateway IP address is on the same subnet as the host
IP address. Check with your system administrator.
• When inputting IP addresses into the IP 710, use the
* key to enter
periods. For example, 209.120.12.8 would be input as 209*120*12*8.
Gateway
Network >
Gateway
Sets the default Gateway IP address.
For H.323 version of phone firmware only:
Enable
GateKeeper Network >
Enable GK
Sets whether GateKeeper is enabled
or disabled.
GateKeeper
Discovery Network >
GK Discovery
Sets whether GateKeeper discovery is
enabled. IP phone will automatically
find GateKeeper. Shows only if
GateKeeper is enabled.
NAT Address
Network >
NAT Address
Sets the NAT server’s public IP
address.
Setting Menu Path Description