AltiGen IP 710 - Manual (Page 23)

IP 710 Manual
15
—CHECK FW (Firmware checking state)
—INIT NETWORK
—LOADING FW...
—LOADING NOW.
—Boot Done
—INITIALIZING
To Use IP 710 in Power over Ethernet Mode
1. Unplug the power cord.
2. Remove the screw on the PoE Module cover, and remove the cover.
3. Plug in the PoE Module as illustrated below. The side with four pins
in the middle faces the top.
Note the centered
pins are at the top
4. Put the PoE module cover back, and tighten the screw.
5. Move the DC/PoE switch to the PoE position.
6. Connect the phone to an AltiGen-certified PoE-enabled switch.