Agasio A501W - Manual (Page 8)

5.1 Start the Video
Video can be start by the following three methods:
 Select and double click on a device needed to be started; a free channel will be taken
to show up the video.
 Select a device and click the button will start it as well. By clicking on the
down arrow, start all the devices command can be found on the drop list.
 Select a device, drag and drop it to a channel, it will show up the video in this
channel.
Device name will be shown in green on the status bar when it's started.
In case the device is offline, or IP address, port, viewing username or password is wrong,
the connection could not be established, and related information will be pop-up.
5.2 Alarm Trigger
1） After started a video, the application will detect the device to determine if there's any
alarm occurred.
2） Whenever an alarm is detected, the application will check the armed time, once the
alarm is within an armed time, alarm action will be taken.
3） When a icon twinkling on the device field, means an alarm action is being taken,
click on the icon can stop the siren.
4） When a appears but not twinkling, means there was an alarm, double click on
the icon will pop-up a recent alarm list. The icon will disappear by closing
the alarm list. The alarm list window is as Figure 9.
Figure 9: Alarm List window
5） Even the video alarm recording trigger is set, it will not take any effect in case it is
taking a scheduled recording job or capturing a video manually by the time an alarm
activated.
6） In case snapshot trigger is set, the file name will be started with an A prefix following
by the time stamp as the other part, the suffix is .JPG.
7） Please refer to chapter 8.1 for the option of alarm action.