Acura 2003 NSX - Owner's Manual - Manual (Page 81)

If the wind noise is unpleasant while
you are driving with the roof panel
removed, you can reduce the noise
by inserting a plug in the hole
located at each side of the rear roof
pillar. These plugs are stored in the
glove box.
Do not use any plugs other than the
ones that came with your car. Other
objects may damage the mechanism
in the roof pillar, causing the roof
panel mechanism to jam or to not
latch the roof properly.
Because it is stored above the engine
compartment, the roof panel can get
hot while driving. Allow it to cool
down for several minutes before
attempting to remove it from the
roof holder.
Remove the roof from the holder
by pulling it up slightly, then back.
Make sure the roof panel release
levers are in the unlocked (down)
position.
Open the roof cover by pulling up
the release lever. Unsnap the hook
from the window frame and use it
to hold up the roof cover.
Open the rear window (see page
).
Remove the plugs from the rear
pillars.
Turn off the engine and set the
parking brake.
Open both windows. 1.
2.
3.
4.
5.
6.
7.
75
Installing
Removable Roof Panel
Instruments and Controls 78
PLUG
Main Menu Table of Contents