Acura 2004 NSX - Owner's Manual - Manual (Page 88)

The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
ON/OFF button. The power antenna
will extend.
Adjust the volume by turning the
VOL dial (outside ring of the left
knob).
You can use any of four methods to
find radio stations on the selected
band:
the preset
buttons, and
Use the TUNE dial
(outside ring of the right knob) to
tune the radio to a desired frequency.
Turn the dial right to tune to a
higher frequency, or left to tune to a
lower frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or side of the bar,
then release it.
The preset frequencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio fuse is
removed.
You can store eight
stations on each band.
Select the desired band, AM or
FM.
Use the TUNE or SEEK function
to tune the radio to a desired
station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 to 3 to store a total
of eight stations on both AM and
FM band.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, STEREO
will be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
1.
2.
3.
4.
Playing the Radio
Comf ort and Convenience Features
To Play the Radio
To Select a Station
TUNE, SEEK,
AUTO SELECT.
TUNE
SEEK
Preset
85
Main Menu Table of Contents