Acura 2004 RL - Owner's Manual - Manual (Page 178)

The SCAN function gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the stations within that
category are scanned. To activate
SCAN, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.
Pick the preset button you want
for that channel. Press and hold
the button until you hear a beep.
Repeat steps 2 to 3 to store the
first six channels.
You can store up to 12
preset channels using the six preset
buttons. Each button stores one
channel from the XM1 band and one
channel from the XM2 band.
To store a channel:
To store a channel:
Press the SAT Radio button until
XM1 or XM2 appears in the
display.
Once a channel is stored, simply
press and release the proper preset
button to tune to it.
Press the SAT Radio button again.
The available XM band will show.
Store the next six channels using
steps 2 through 3.
The presets will be lost if your car’s
battery goes dead, is disconnected,
or the radio fuse is removed. In the category mode, only channels
within that category can be selected.
In the channel mode, all channels
can be selected.
Use the TUNE knob, or the
CATEGORY or SCAN buttons to
tune to a desired channel.
1.
2.
3.
4.
5.
CONTINUED
Audio System
Comf ort and Convenience Features
SCAN
Preset
175
Main Menu Table of Contents