Acura 2006 RL - Owner's Manual - Manual (Page 206)

The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the AM/FM button (AM or FM
button on Canadian, Alaskan and
Hawaiian models). You can also
change bands by pushing the
interface selector up. Each time you
push it up, the band will change to
FM1, FM2, or AM. On the FM bands,
STEREO will be shown on the
navigation screen and ST on the
upper display, if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
Use the TUNE button to
tune the radio to a desired frequency.
Press the
button to tune to a
higher frequency, or the button
to tune to a lower frequency. To tune
with the interface dial, push the
selector down, and turn the knob to
TUNE. Then press ENTER on the
selector, and turn the knob to the
desired frequency. To exit the
TUNE mode, press ENTER on the
selector. You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and .
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button (AM or FM button on
Canadian, Alaskan and Hawaiian
models). Adjust the volume by
turning the power/volume knob.
CONTINUED
TUNE To Play the AM/FM Radio
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
Playing the AM/FM Radio
Fe
a
tu
re
s
205
STEREO ICON
TUNE ICON
BAND
Main Menu Table of Contents