Acura 2006 MDX - Owner's Manual - Manual (Page 158)

Unplug the garage door opener
motor from the electrical outlet.
Hold the end of the garage door
opener remote transmitter 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time.
Plug in the garage door opener
motor, then test the HomeLink
button by pushing it for about 1
second.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
continues to flash slowly (does
not begin to flash rapidly),
repeat steps 2 thru 4.
If the button does not work
go to step 6.
If the button works,
programming is complete.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitter may stop
transmitting after a short time.
Go to step 4.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 5.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 5.
2.
3.
1.
5.
4.
HomeLink Universal Transceiver
Fe
a
tu
re
s
157