Acura 2006 MDX - Owner's Manual - Manual (Page 109)

The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
Select and Fresh Air mode.
Set the fan to the desired speed.
Adjust the warmth of the air with
the temperature control buttons.
Press the A/C-INFO button to
show the information screen.
Select the desired mode by
touching the MODE icon, and set
the fan to the desired speed by
touching the
or icon.
Adjust the warmth with the
temperature control buttons (
or
).
Air flows from the defroster
vents at the base of the windshield.
When you select , the system
automatically switches to fresh air
mode and turns on the A/C.
The flow-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents near the rear side
panels.
Set the temperature to maximum.
Make sure the A/C is off.
Select
and Fresh Air mode.
Set the fan to the desired speed.
Use the mode control button or icon
to select the vents the air flows from.
Regardless of what mode you
are in, air flows out of the corner
vents unless the system is shut off or
the vent is manually shut off.
Air flows from the center
vents in the dashboard.
Airflow is divided between
the vents in the dashboard and the
floor vents.
Air flows from the floor
vents.
Airflow is divided between
the floor vents and the defroster
vents at the base of the windshield.
1.
2.
3.
1.
2.
3.
4. 1.
2.
3.
Vehicles without Navigation System
Vehicles with Navigation System
Vents, Heating, and A/C
Using the Heater
Ventilation
Mode Control Button/Icon
108
NOTE: