Compass – Acura 2007 MDX - Owner's Manual User Manual

Page 274

Press and hold the SET button for
five seconds until the Clock
display changes to ‘‘ZON? N.’’
(Please note that clock adjustment
mode will be started after the first
two seconds.)

When the display goes from
‘‘

’’ to an actual heading, the

unit is calibrated and the display
returns to normal.

Do this procedure in an open

area, away from buildings, power
lines, and other vehicles.

In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:

Press the

button. ‘‘ZOY? Y’’ will

be displayed.

Find the zone for your area on the
map.

If the zone is incorrect, press the

button to cycle the count down,

or the

button to cycle the count

up. Once the correct zone is
displayed, continue to step 6.

Press the SET button to set the
zone selection.

Press and hold the SET button for
about 5 seconds to exit the zone
selection and return display to
normal.

Press the SET button. The zone
the compass is currently in will be
displayed.

Compass

Compass Zone Selection

270

NOTE:

Main Menu

Table of Contents