Acura 2007 MDX - Owner's Manual - Manual (Page 204)

The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button. Adjust the volume by turning
the power/volume knob.
The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the AM/FM button. You can also
change bands by pushing the
interface selector up. Each time you
push it up, the band will change to
FM1, FM2, or AM. On the FM bands,
STEREO will be shown on the
navigation screen and ST on the
audio display, if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency. To tune with the
interface dial, push the selector
down, and turn the knob to TUNE.
Then press ENTER on the selector,
and turn the knob to the desired
frequency. To exit the TUNE mode,
press ENTER on the selector.
You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and .
To Play the AM/FM Radio TUNE
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
Playing the AM/FM Radio (Models with navigation system)
200
STEREO ICON
TUNE ICON
BAND
Main Menu Table of Contents