Acura 2007 MDX - Owner's Manual User Manual

Page 189

The SCAN function gives

you a sampling of all channels while
in the channel mode. In the category
mode, only the stations within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.

You can store up to 12

preset channels using the six preset
buttons. Each button stores one
channel from the XM1 band and one
channel from the XM2 band.

To store a channel:

Press the XM button. Either XM1
or XM2 will show in the display.

The presets may be lost if your
vehicle’s battery goes dead, is
disconnected, or the radio fuse is
removed.

XM is loading the

audio or program information.

The channel

currently selected is no longer
broadcasting.

The encryption

code is being updated. Wait until the
encryption code is fully updated.
Channels 0 and 1 should still work
normally.

Once a channel is stored, simply
press and release the proper preset
button to tune to it.

Press the XM button again. The
other XM band will show. Store
the next six channels using steps 2
and 3.

Repeat steps 2 and 3 to store the
first six channels.

Pick the preset button you want
for that channel. Press and hold
the button until you hear a beep.

Use the TUNE knob, or the
CATEGORY or SCAN buttons to
tune to a desired channel.

In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.

CONTINUED

SCAN

Preset

XM Radio Display Messages

‘‘LOADING’’

‘‘OFF AIR’’

‘‘UPDATING’’

Playing the XM Satellite Radio (Models without navigation system)

Fe
a

185

Main Menu

Table of Contents