Acura 2009 MDX - Owner's Manual - Manual (Page 143)

Keyless Memory Settings ™
When you unlock the driver's door
with your remote, each remote
activates the keyless memory
settings related to that remote. The
driver's ID (MEMORY 1 or
MEMORY 2) is shown on the back of
each remote.
Here are the settings activated with
the remote:
● Customized settings
(see page
83 ).
● Driving position memory
(see page
157 ).
●
Audio system settings
(see page
200 ).
●
Climate control settings
(see page
171 ).
When you unlock and open the
driver's door with the remote
transmitter, the driver's seat (except
the power lumbar feature) and
outside mirrors start to move to the
positions stored in memory. The
indicator in the related memory
button to the remote comes on.
The steering wheel will move to the
stored position when you insert the
key into the ignition switch.
You will also see the ‘‘WELCOME
DRIVER 1 ’’ or ‘‘WELCOME DRIVER
2 ’’ message on the multi-information
display, depending on which linked
remote transmitter is used.
To turn off this feature, press and
hold the LOCK and UNLOCK
buttons at the same time. The LED
in the remote will blink twice. Then
release the buttons. Doing this
cancels the keyless memory settings
for that remote and restores the
default settings.
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink once to indicate the
feature has been turned on.
Remote Transmitter
139
Inst
rument
s
a
nd
Cont
rols
08/06/06 16:58:07 09 ACURA MDX MMC North America Owner's M 50 31STX620 enu
2009 MDX
Table Of Contents Main Menu