Important, Installation i (joist mounting -i ) continued, Caution – Panasonic FV-13VKML3 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. (Fig.5)
INSTALLATION I (JOIST MOUNTING -I ) CONTINUED
IMPORTANT:
Remove the tapes from louver and springs
before installation. As shown below:
FV-13VKML3
FV-08VKML3
FV-13VKSL3
FV-08VKSL3
FV-13VKL3 FV-08VKL3
Install fluorescent lamp and night lamp as below:
Light cover
® Remove screw ®
(M4X8)
Gloves
Fluorescent
lamp
Night lamp
CAUTION:
■ Before turn on the light, make sure the connector
at the correct position.
■ The claw of connector must latch the rib
completely. (Fig.6)
8. Insert the grille mounting spring on the wiring side
into the slot and insert the plug connector I into
the housing of the lighting unit. (Fig.6)
9. Insert the sensor unit into slot of the grille;
Fix the lead wire of sensor unit into the clasp
(1 position). (FV-13VKML3 and FV-08VKML3).(Fig.7)
10. Adjust high / low delay time preset switch and low
speed air volume preset switch (Fig.8).
Refer to switch indication on page 7. (FV-13VKML3,
FV-08VKML3, FV-13VKSL3 and FV-08VKSL3)
11. Insert another mounting spring into the slot as
shown and mount grille to fan body. (Fig.9)
CAUTION:
Mount grille carefully so that lead wire of sensor
unit and lighting unit is not pinched.
Ceiling...^
Mounting spring
Grille-^
1 (^Gioves
r—r* Fig.9