Setup menu – Cary Audio Design Cinema 11 User Manual

Page 37

SETUP MENU

SET ANALOG IN LEVEL SETTINGS

This adjustment can be used to adjust 2-channel analog audio input levels for a selected input.
Despite attempts at standardization, analog sources still have a wide range of input levels. To

compensate for this, the Cinema 11 allows independent input level adjustment for each of the

stereo analog audio input connectors. Input level adjustment is not available for the 7.1 channel

analog audio input connector.

NOTE: The following selected menus appear on the Cinema 11 Display.

SETUP MENU
Input

To set Analog IN Level:

1. Press the SETUP button to enter the SETUP MENU.

The SETUP MENU / SPEAKER appears.

2. Press

the

button until INPUT is selected.

The SETUP MENU/ INPUT menu appears.

3. Press the ENTER button to enter the CHANGE INPUT NAMES setup menu.

4. Press the

button until SET ANALOG IN LEVEL is selected.

5. Press the ENTER button to enter the INPUT 1 level adjustment menu.

6. Use the

and

buttons to adjust the level of the INPUT 1.

You can adjust the selected channel level in 1.0 dB steps across a range of -18dB to

+12dB.

7. Press the

button when you have made a selection.

Repeat steps 6 for the INPUT 2, INPUT 3, INPUT 4, INPUT 5, INPUT 6, INPUT 7 and

INPUT 8.

8. Press the

button to select BACK and press the ENTER to return to the SETUP MENU,

or press the SETUP button to exit the SETUP MENU.

SET ANALOG IN CONFIG

The Cinema 11 allows analog sources to select bypass mode or DSP mode. When you select the
BYPASS mode, the Cinema 11 passes analog input signals directly to the main audio output

connectors. When you select DSP mode, the Cinema 11 sends analog input signals through A/D

conversion and internal processing before passing them to the main audio output connectors.

This allows analog sources to use bass management, speaker crossovers, speaker distance

calibration, and Room EQ.