Cary Audio Design Cinema 11 - Manual (Page 17)

CONTROLS AND DISPLAYS
16
REAR PANEL
1. ANALOG AUDIO IN (INPUT 1) XLR (L + R)
• Use these jacks for connection to balanced CD or DVD player analog output
connections.
2. ANALOG AUDIO IN (INPUTS 2 THROUGH 8) RCA
• Use these jacks for connection to CD, DVD, TV, or VCR input options.
3. ANALOG AUDIO 7.1 INPUT
• By connecting a DVD audio player, SACD multi channel player, or other component
that has a multi-channel output, you can playback the analog audio with 5.1 channel or
7.1 channel outputs.
4. 2 ND ZONE ANALOG AUDIO OUT
• These jacks supply the analog stereo audio outputs to an external audio amplifier used
to power the speakers in the remote zone.
5. 7.1 PREAMPLIFIER OUTPUTS
• Use these jacks to connect to the main five or seven channel power amplifiers.
6. 7.1 PREAMPLIFIER OUTPUTS XLR
• Use these jacks to connect to the main five or seven channel power amplifiers.
7. AC INLET CONNECTOR
• Plug the power cord into this AC inlet and then into the power outlet on the wall.
8. DC TRIGGER OUTPUT TERMINALS
• Connect devices that need to be triggered by DC + 12V. (Screen, curtains, lights, etc.)
9. IR INPUT
• Use the 1 and zone 2 Ext remote jacks to connect external IR sensors. When the unit
is installed where it is not otherwise visible to the remote, connect an optional, external
sensor and the 1 (Main) jack will be activated. The Cinema 11 should be used for
connections to the power amplifiers for the main room speaker. The device connected
to the zone trigger will only be activated when the Multi-Zone system is turned on.
Connect it to the amplifier used to power the speakers in the second zone (Zone 2).