Cary Audio Design Cinema 11 - Manual (Page 26)

AUTO SOUND SETUP
25
Speaker check
FL ......................................Yes (Yes/No)
CEN ...................................Yes (Yes/No)
FR......................................Yes (Yes/No)
SR .....................................Yes (Yes/No)
SBR....................................Yes (Yes/No)
SBL ....................................Yes (Yes/No)
SL......................................Yes (Yes/No)
SW.....................................Yes (Yes/No)
Total: 8 speakers
Press ENTER now.
Note: The speaker check measures the state of use of all speakers whether actually
used or not. For example, if the CEN speaker is not used, the test tone will require
time to go from the FL to the FR, therefore be careful not to unplug the microphone or
operate the Cinema 11 during this time.
6. When the speaker check ends, the following VFD appears on the display.
Total: 8 speakers (or however many speakers are connected)
Press ENTER now
The results of the speaker check will be displayed. The front panel shows confirmation of
the number of speakers detected. If some speakers are not detected, make sure that
they are all connected properly. After confirming the total number of speakers, press the
ENTER button.
7. Set Distance
During Set Distance testing, the following VFD appears on the display and checks are
made to detect dart sound in the listening room, whether there are speakers connected
to each channel or not and the polarity of the speakers as they are connected.
Set Distance
FL .......................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
CEN ....................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
FR.......................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
SR ......................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
SBR........................ 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
SBL ........................ 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
SL.......................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
SW......................... 0.0ft 0.00m (0.0ft to 100ft/ 0.00m to 30.3m)
8. Set Balance
During Set Balance testing, the following VFD appears on the display and checks are
made to detect the test sound in the listening room, whether there are speakers
connected to each channel or not and the polarity of the speakers as they are connected.