Base settings – Clarity D722 User Manual

Page 21

Program the Direct Memory Keys on base

There are four direct memory keys on the base, which share the same phone
number with Speed Dial locations under keys 0 through 3 on the handset. The
corresponding relastion is as follows:

Direct memory key M0 = Speed Dial location for key "0" on the handset
Direct memory key M1 = Speed Dial location for key "1" on the handset
Direct memory key M2 = Speed Dial location for key "2" on the handset
Direct memory key M3 = Speed Dial location for key "3" on the handset

In idle mode, press any direct memory key on the base to dial out the
corresponding number from the base (using the base speaker).

You have to assign numbers to these direct memory keys first (also detailed in
section Speed Dial Numbers).

Using the handset, follow the steps below:

1. In idle mode, press

, then to select

Directory.

2. Press

, then to select Speed dial.
3. Press , then to select an empty speed

dial location (for the base memory locations, use keys "0", "1", "2" or
"3").

4. Press

to access the directory list, then press

DOWN> to select the desired directory entry.

5. Press

to save. The name of the desired directory

entry appears in the selected speed dial location.

Note:

If the speed dial location you selected is occupied, the new directory entry
you selected replaces the old one. Take caution not to replace entries you
do not wish to delete from the speed dial locations.

Change the Dial Mode
The default dialing mode is suitable for your country and network operator. It
is unlikely that you should need to change this setting unless advised to do so.

1. Press

, then to select Settings.
2. Press , then to select Dial Mode.
3. Press , then to select Tone or

Pulse.

4. Press

to confirm.

Set the Home Area Code
If you dial seven digits to make a local call (no area code required), enter your
area code into the telephone as the home area code. When you receive a call
from within your home area code, the caller ID history only displays the seven
digits of the telephone number.
This feature makes it easy for you to place a call from the caller ID history.
If you dial 10 digits to make a local telephone call, do not use this home area
code feature. If you do, you will not be able to place calls from your caller ID
history as they have only seven digits.

1. Press

, then to select Settings.
2. Press , then to select Home area

code.

3. Press

, then enter the home area code. Only three

digits in maximum can be entered.

4. Press

to confirm.

Note: If, in the future, your telephone service provider requires you to dial
10 digits to make a local call (area code + telephone number), you will need
to delete your home area code. While the home area code is displaying in step
2 above, press and hold MUTE/X. The home area code is now restored to its
default setting of _ _ _ (empty).

BASE SETTINGS

This manual is related to the following products:

D724