FRITSCH LABORETTE 17, size II - Manual (Page 10)

DANGER!
Explosion hazard!
– When dispersing oxidizable substances, e.g. metals or
coal, there is a risk of spontaneous combustion (dust
explosion) if the share of fine particles exceeds a cer-
tain percentage. When dispersing these kinds of sub-
stances, special safety measures must be taken and the
work must be supervised from a specialist.
– The high-speed rotor mill is not explosion protected
and is not designed to disperse explosive materials.
n Do not remove the information signs.
NOTICE!
Immediately replace damaged or illegible information signs.
n Unauthorised alteration of the the LABORETTE 17 will void Fritsch's
declaration of conformity to European directives and void the guar-
antee.
n Only use the the LABORETTE 17 when it is in proper working order,
as intended and in a safety- and hazard-conscious manner adhering
to the operating manual. In particular, immediately rectify any mal-
functions that could pose a safety hazard.
n If, after reading the operating manual, there are still questions or
problems, please do not hesitate to contact our specialised per-
sonnel.
1.6 Hazardous points
DANGER!
– Do not use the device without liquid. This could result
in damage to the piezoceramic oscillator or the elec-
tronics.
– Do not put anything on the base of the bath. This could
result in damage to the base of the bath. Use the 6 L
Version (17.3100.00) or the 28 L Version (17.5100.00)
of the insert tray, which is available as an accessory.
– During ultrasonic cleaning, do not put your hand in the
cleaning fluid due to the danger of thrombosis or blood
thickening.
Safety information and use
- 10 -