Freerider FR1 - Manual (Page 23)

22
2.Charging Circuit Fuse:
One fuse protects your Scooter charging circuit from receiving an overload of
electrical current. The fuse used in the Scooter is the same type which is found on
automobiles. In the unlikely event that a fuse should 'blow' and needs replacing.
use only a fuse of a 15amp rating. Please note this size of fuse has been selected to
give your Scooter the best protection without premature fusing.
Warning: Do not use fuses with a higher rating than 15amps as this may cause
permanent failure to the wiring and wiring connectors or personal injury. For access
to a fuse remove the four screws located in the rear body cover, lift cover. Locate and
lift the fuse block on it's wire, lift up the fuse
lid and withdraw the 'read' fuse. Replace the blown fuse with recommended 15 amp
(pink) fuse, close fuse lid and replace fuse block.
use only a fuse of a 15amp rating. Please note this size of fuse has been selected
to give your Scooter the best protection without premature fusing.